The error was: No such service is > > known. Also run on the member server: w32tm /config /syncfromflags:domhier /update After that you have to run: net stop w32time net start w32time Then check the event viewer again.Best regards Meinolf Weber Open a command prompt, enter net stop w32time w32tm /unregister w32tm /register net time /setsntp:184.108.40.206 net start w32time A few minutes after the "net start" command, you should see an entry The service cannot be > found > in the specified name space. (0x8007277C) > > For more information, see Help and Support Center at > http://go.microsoft.com/fwlink/events.asp. > > how can i navigate to this website
Join & Write a Comment Already a member? Change its value to another time server. and how to lookup it ??? 0 Cayenne OP Tomer Nagar May 5, 2010 at 3:38 UTC You can edit the registry to amend this name. In addition to the troubleshooting suggestions “Meinolf Weber” provided, I also would like to suggest you check apply the following hotfix: Name resolution may fail on a Windows Server 2003
x 19 EventID.Net This may occur on a Windows XP machine when there is no Internet connectivity. SVCHOST uses UDP port 123 to connect to the timeserver.Hello Again,Btw how to allow UDP port 123?ThankssHen 0 Share this post Link to post Share on other sites malmal 0 Stop and start the W32time service from the cmd line by typing: net stop w32time && net start w32time 0 Mace OP Yasaf Burshan May 5, 2010 at Perform the following procedure on the computer that is logging the event to be resolved.
At the top of the Start menu, right-click Command Prompt, and then click Run as administrator. If ten years ago it was still common to see an entire company using just one server, these days that's no longer the case. Verify To perform this procedure, you must have membership in Administrators, or you must have been delegated the appropriate authority. Windows Event Id 17 To resynchronize the client with time source peer: Open a command prompt as an administrator.
Did the page load quickly? Time Provider Ntpclient An Error Occurred During Dns Lookup x 57 Private comment: Subscribers only. NtpClient will try the DNS lookup again in 15 minutes. have a peek at this web-site The list may consist of one or more DNS names or IP addresses (if DNS names are used then you must append , 0x1 to the end of each DNS name).
The time now is 07:18 AM. -- Generic Blue ---- Generic Blue - Fixed -- TT Blue -- Mobile Contact Us - TechTalkz.com Technology & Computer Troubleshooting Forums - Top vBulletin, Event Id 17 Bthusb NtpClient will try >> > the DNS lookup again in 240 minutes. can you copy the solutions from expert exchange?? Choose a time server located near you (you can look for example in the list linked below, or your Go to Solution 1 Comment LVL 82 Overall: Level 82 Active
http://www.microsoft.com/resources/d....mspx?mfr=true There are many internet time sources available. Best regards Meinolf Weber Disclaimer: This posting is provided "AS IS" with no warranties, and confers no rights. > thanks for ur reply > it's a dc > can u tell Event Id 17 Whea-logger If DC, you have to check if it is the PDCEmulator where you configure the, i assume, external time source. Event Id 17 A Corrected Hardware Error Has Occurred Creating your account only takes a few minutes.
To confirm that the Windows Time service synchronized successfully with a time source peer, verify that Event ID 37 appears in Event Viewer. read more... The error was: No such service is known. http://forumyaren.com/event-id/w32time-error-event-id-14.php In Start Search, type Command Prompt.
The system tries to resolve the name of the time server but it fails. Event Id 17 Rbac If you do not append ,0x1 to the end of each DNS name, the changes will not take effect. Even with 5 minutes per server (to check the logs and other parameters), it may take an hour to make sure that everything is ok and no "red lights" are blinking
The standard profile controls the firewall when not connected to your domain, so they could not synchronize with your DCs anyway. NtpClient will try > the DNS lookup again in 240 minutes. If it mentions an ip address the DNS works OK. (Pinging will fail however, the MS timeserver doesn't reply to ping packets).Your problem can also be caused by a firewall. Event Id 17 Windows 10 When I put this server 2003 out of domain (in workgroup) and again in domain I getting W32Time Event ID: 17, 27, 47, 48 System events.
No attempt to contact a source will be made for 14 minutes. You must append ,0x1 to the end of each DNS name. NtpClient will try > > the DNS lookup again in 240 minutes. get redirected here The Windows Time service (W32time) synchronizes time between computers within the hierarchy, with the most accurate reference clocks at the top.
NtpClient has no source of accurate time. NtpClient will try the DNS lookup again in %3 minutes. Feedback: Send comments or solutions - Notify me when updated Printer friendly Subscribe Subscribe to EventID.Net now!Already a subscriber? First lets open up your group policy console and edit the policy you want to add it to.